Page 130 - 2010 - AOUT
P. 130
ject...Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...
By AIM Member
Annemarie Kwikkel ‐ IGMA Artisan
After sculpting a gourmet chef tasting his culinary creation I
needed to make a nice hat for him, here is the tutorial I created.
You will need:
2 pieces of thin cotton: 16x4.5 cm ( 6.3x1.75
inch) and 7x1.5 cm (2.75x0.6 inch). Tacky glue.
Smallest sized pleater. Small bottle cap.
Scissors and tweezers. Needle and thread.
Iron. A clean brush, water and fabric stiffener.
13
2
Take the larger piece of piece of cotton and insert it into the pleater following the instructions. With your brush
wet the cotton with fabric stiffener diluted with water. Leave to dry in the pleater, or, you could also use a hair
dryer to speed up this process.
Taking the smaller piece of cotton, fold and glue hems into place along the two long sides
Artisans In Miniature 130
Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...
By AIM Member
Annemarie Kwikkel ‐ IGMA Artisan
After sculpting a gourmet chef tasting his culinary creation I
needed to make a nice hat for him, here is the tutorial I created.
You will need:
2 pieces of thin cotton: 16x4.5 cm ( 6.3x1.75
inch) and 7x1.5 cm (2.75x0.6 inch). Tacky glue.
Smallest sized pleater. Small bottle cap.
Scissors and tweezers. Needle and thread.
Iron. A clean brush, water and fabric stiffener.
13
2
Take the larger piece of piece of cotton and insert it into the pleater following the instructions. With your brush
wet the cotton with fabric stiffener diluted with water. Leave to dry in the pleater, or, you could also use a hair
dryer to speed up this process.
Taking the smaller piece of cotton, fold and glue hems into place along the two long sides
Artisans In Miniature 130
Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...Project...
